Page 1 of 1

Some eScan 10 (RC1/5) problem in localization...

PostPosted: Fri Nov 21, 2008 1:58 pm
by Sidney
Hello all,
I had try to translate sysinfo.lan into Chinese words.
I found some problem in System info if the language is Chinese.
In the System Info screen, if you click on left frame for System Hardware, Storage, Network Adaptor... etc. , the right frame will show the icon with names like "input device", "Mass Storage"... etc.
If you use Chinese words, the left frame will be OK, but the right frame icon with names will get some error for Chinese words shown.
The Chinese names for the icon will show show some codes NOT Chinese words, and NOT English words.
It will show like wild codes. Please take a look for this.

PostPosted: Tue Dec 02, 2008 6:18 pm
by Varghese
Can you send us the snap shots of the same so that we could sort out the issue.

You could send the mails to qa@mwti.net

PostPosted: Wed Dec 03, 2008 9:51 am
by Sidney
Hello Sir,
I had sent the screen snap to qa@mwti.net .
Please check it. Thank you.

PostPosted: Mon Dec 15, 2008 1:53 pm
by Varghese
Hello Sidney,

Thanks for you reply. This will be took care of and I'll respond to you according to the changes needed or to be made.